E Ink Display
Los 10 mejores productos de mayo de 2025
Última actualización:
21 de mayo de 2025
IBest
2.13inch E-Paper Display Hat V4 Version 250x122 Resolution 3.3V/5V Two-Color e-Ink Display epaper Screen for Raspberry Pi Zero/Zero W/Zero WH/3B/3B+/4B, Partial Refresh, SPI Interface
13% Descuento
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#1 GANADOR
▼ Mostrar más
▲ Mostrar menos
Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs,Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
No backlight, keeps displaying last content for a long time even when power down
18,14 € EN AMAZON
Waveshare
Waveshare 7.5 Inch E-Paper Raw Display Panel V2 800x480 Resolution 3.3V E-Ink Electronic Paper Screen Without PCB with Embedded Controller,Communicating Via SPI Interface
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#2
▼ Mostrar más
▲ Mostrar menos
Note:Version 2 please use corresponding demo code in wiki.This is an E-Ink raw display, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface.Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
Ultra low power consumption, basically power is only required for refreshing
Comes with development resources and manual (driver board schematic, examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
No backlight, keeps displaying last content for a long time even when power down，Comes with development resources and manual (driver board schematic, examples for Raspberry Pi/Arduino/STM32)
Note that you cannot use Partial refresh all the time, you should full refresh e-paper regularly, otherwise, ghost problem will get worse even damage.Please set the e-Paper to sleep mode or power off it directly, otherwise, the e-Paper is damaged because of working in high voltage for long time. You need to update the content of three-color e-Paper at least one time every 24h to avoid from burn-in problem.
67,99 € EN AMAZON
Waveshare
Waveshare 4.2Inch E-Paper Display Panel Module Kit 400 x 300 Resolution 3.3v E-Ink Electronic PaperScreen,Embedded Controller for Raspberry Pi/Arduino/Nucleo Support Full Refresh SPI Interface
Envío gratis
93
CALIDAD EXCELENTE
VER EN AMAZON
Amazon.es
#3
▼ Mostrar más
▲ Mostrar menos
This is an E-Ink display module, 4.2inch, 400x300 resolution, with embedded controller, communicating via SPI interface.
Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down.SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
Ultra low power consumption, basically power is only required for refreshing
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32).Onboard voltage translator, compatible with 3.3V/5V MCUs.
43,99 € EN AMAZON
LUCKFOX
LUCKFOX 7.3-Inch e-Paper Hat (F), 7-Color e-Ink Screen with PCB, 800x480 Pixels, Low Power Consumption - for Raspberry Pi/Jetson Nano/STM32, Suitable for Electronic Shelf Labels, Meeting Badges, etc
Envío gratis
90
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#4
▼ Mostrar más
▲ Mostrar menos
Advanced Color ePaper technology with an ACeP seven-color display and a resolution of 800x480
Low power consumption with minimal power usage during refresh and long-lasting display in case of a power outage
SPI Control interface compatible with Raspberry Pi/Jetson Nano/STM32, and other control boards
Onboard level shifting chip supporting 3.3V and 5V interfaces, adding to its versatility
Compatible with usage in applications such as electronic shelf labels, pricing tags, meeting badges, and more
87,99 € EN AMAZON
Waveshare
Waveshare 7.3 Inch ACeP 7-Colour E-Paper with Solid Wood Photo Frame, Ultra-Long Standby, 800 x 480 Resolution, Suitable for Content Displays, Calendars, Paintings,Posters, Batteries Are Not Included
Envío gratis
86
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#5
▼ Mostrar más
▲ Mostrar menos
Advanced Color ePaper (ACeP) technology, supports 7-Color display
Ultra-low power consumption, basically power is only required for refreshing
Onboard power saving circuit, allows thousand times of refreshing by one charge
Onboard RTC chip for timing refresh. Simple solid wood photo frame, elegant and beautiful
Rotatable stand and hook hanger on the back, not limited to usage scenarios. Open source code, more freedom to customize functions
103,99 € EN AMAZON
Waveshare
Waveshare 2.15inch e-Paper Hat+ (G), Compatible with Raspberry Pi 5/4B/3B/Zero/Zero W/Zero 2W/Pico/Pico W/Pico WH, 296x160, Red/Yellow/Black/White, SPI Interface E-Ink Display with Driver Board
Envío gratis
82
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#6
▼ Mostrar más
▲ Mostrar menos
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano, RDK X3 Adopts Raspberry Pi HAT+ standard to improve interoperability, helping the users to design and develop faster, easy to use with other peripherals and extend more functions for Raspberry Pi
Adapting SPI interface for connecting with controller boards like Raspberry Pi / Arduino / STM32, etc. Onboard voltage translator, compatible with 3.3V / 5V MCUs
Rich WiKi Resources: We provide official Wiki resources, please contact us for more information.
25,99 € EN AMAZON
Waveshare
Waveshare 7.5 Inch E-Paper Display Hat Module V2 Kit 800x480 Resolution 3.3v/5v E-Ink Electronic Screen with Embedded Controller SPI Interface Compatible with Raspberry Pi/Jetson Nano/Arduino/STM32
Envío gratis
79
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#7
▼ Mostrar más
▲ Mostrar menos
Note:Version 2 please use corresponding demo code in wiki.This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down.Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs.Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Note that you cannot use Partial refresh all the time, you should full refresh e-paper regularly, otherwise, ghost problem will get worse even damage.Please set the e-Paper to sleep mode or power off it directly, otherwise, the e-Paper is damaged because of working in high voltage for long time. You need to update the content of three-color e-Paper at least one time every 24h to avoid from burn-in problem.
69,99 € EN AMAZON
Waveshare
Waveshare 7.3inch 6-Color E-Paper Screen with Driver Board, E-Ink Display(E Type), Low Power Consumption, 800x480 Pixel, SPI Communication, Suitable For Price Tag, Asset/Equipment Tag, Shelf Label...
Envío gratis
78
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#8
▼ Mostrar más
▲ Mostrar menos
7.3inch e-Paper HAT (E) - with e-Paper Driver HAT. Adopts E_Ink Spectra 6(E6) technology, supports 6-Color display. Onboard voltage translator, compatible with 3.3V / 5V MCUs
No backlight, keeps displaying last content for a long time even when power down. With standard Pi 40PIN GPIO extension header for Raspberry Pi series boards/Jetson Nano
Ultra low power consumption, basically power is only required for refreshing. Adapting SPI interface for Raspberry Pi/Jetson Nano/STM32 controller boards
Can provide with development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/STM32)
Suitable For Price Tags, Asset/Equipment Tags, Shelf Labels, Conference Name Tags...
107,99 € EN AMAZON
Waveshare
Waveshare 3.52inch e-Paper Display (B), e-Ink Display, 360x240, Red/Black/White, Compatible with Raspberry Pi 5/4B/3B/Zero/Zero W/Zero 2W/Pico/Pico, Support Jetson Nano/TX2/Xavier N/Orin and RDK X3
Envío gratis
72
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#9
▼ Mostrar más
▲ Mostrar menos
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano, RDK X3. Onboard voltage translator, compatible with 3.3V / 5V MCUs
Rich WiKi Resources: We provide official Wiki resources, please contact us for more information.
29,99 € EN AMAZON
Waveshare
Waveshare 2.9 Inch E-Paper Display Panel Module Kit 296x128 Resolution E-Ink Electronic Screen for for Raspberry Pi/Jetson Nano/Arduino/STM32 Support Partial Refresh SPI Interface
Envío gratis
67
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#10
▼ Mostrar más
▲ Mostrar menos
This is an E-Ink display module, 2.9inch, 296x128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh.Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.Onboard voltage translator, compatible with 3.3V/5V MCUs
24,99 € EN AMAZON
e-ink display
e ink
e-ink
e-ink display 32
e ink display raspberry pi
color e ink
e-ink color
e-ink reader
e ink watch
e-ink watch
#1 GANADOR
