Waveshare E Ink
Los 10 mejores productos de octubre de 2025
Última actualización:
9 de octubre de 2025
Waveshare
Waveshare 7.5 Inch E-Paper Raw Display Panel V2 800x480 Resolution 3.3V E-Ink Electronic Paper Screen Without PCB with Embedded Controller,Communicating Via SPI Interface
Envío gratis
99
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#1 GANADOR
▼ Mostrar más
▲ Mostrar menos
Note:Version 2 please use corresponding demo code in wiki.This is an E-Ink raw display, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface.Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
Ultra low power consumption, basically power is only required for refreshing
Comes with development resources and manual (driver board schematic, examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
No backlight, keeps displaying last content for a long time even when power down，Comes with development resources and manual (driver board schematic, examples for Raspberry Pi/Arduino/STM32)
Note that you cannot use Partial refresh all the time, you should full refresh e-paper regularly, otherwise, ghost problem will get worse even damage.Please set the e-Paper to sleep mode or power off it directly, otherwise, the e-Paper is damaged because of working in high voltage for long time. You need to update the content of three-color e-Paper at least one time every 24h to avoid from burn-in problem.
67,99 € EN AMAZON
Waveshare
Waveshare 4.2Inch E-Paper Display Panel Module Kit 400 x 300 Resolution 3.3v E-Ink Electronic PaperScreen,Embedded Controller for Raspberry Pi/Arduino/Nucleo Support Full Refresh SPI Interface
Envío gratis
98
CALIDAD MÁXIMA
VER EN AMAZON
Amazon.es
#2
▼ Mostrar más
▲ Mostrar menos
This is an E-Ink display module, 4.2inch, 400x300 resolution, with embedded controller, communicating via SPI interface.
Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down.SPI interface, for connecting with controller boards like Raspberry Pi/Arduino/Nucleo, etc.
Ultra low power consumption, basically power is only required for refreshing
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32).Onboard voltage translator, compatible with 3.3V/5V MCUs.
43,99 € EN AMAZON
Waveshare
Waveshare 7.5 Inch E-Paper Display Hat Module V2 Kit 800x480 Resolution 3.3v/5v E-Ink Electronic Screen with Embedded Controller SPI Interface Compatible with Raspberry Pi/Jetson Nano/Arduino/STM32
Envío gratis
94
CALIDAD EXCELENTE
VER EN AMAZON
Amazon.es
#3
▼ Mostrar más
▲ Mostrar menos
Note:Version 2 please use corresponding demo code in wiki.This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down.Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
Onboard voltage translator, compatible with 3.3V/5V MCUs.Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)
Note that you cannot use Partial refresh all the time, you should full refresh e-paper regularly, otherwise, ghost problem will get worse even damage.Please set the e-Paper to sleep mode or power off it directly, otherwise, the e-Paper is damaged because of working in high voltage for long time. You need to update the content of three-color e-Paper at least one time every 24h to avoid from burn-in problem.
69,99 € EN AMAZON
Waveshare
Waveshare 3.52inch e-Paper Display (B), e-Ink Display, 360x240, Red/Black/White, Compatible with Raspberry Pi 5/4B/3B/Zero/Zero W/Zero 2W/Pico/Pico, Support Jetson Nano/TX2/Xavier N/Orin and RDK X3
Envío gratis
90
CALIDAD DISTINGUIDA
VER EN AMAZON
Amazon.es
#4
▼ Mostrar más
▲ Mostrar menos
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano, RDK X3. Onboard voltage translator, compatible with 3.3V / 5V MCUs
Rich WiKi Resources: We provide official Wiki resources, please contact us for more information.
29,99 € EN AMAZON
Waveshare
Waveshare 7.5inch E-Paper Hat Display Module, 800×480 Resolution, Supports Black/White 2 Colors, Compatible with Jetson Nano/Raspberry Pi 4B/3B+/3A+/3B/2B/1B+/1A+/Zero 2 W/Zero W/Zero
Envío gratis
84
CALIDAD FIABLE
VER EN AMAZON
Amazon.es
#5
▼ Mostrar más
▲ Mostrar menos
This product has been updated to V2 with 800 x 480 resolution (the V1 has a resolution of 640 x 384). The hardware structure and interface of V2 are for the V1, but the software needs to be updated. If you purchase it for the first time, and there is a V2 label on the back of the screen, you can directly use the program for V2.
This is an E-Ink display HAT for Raspberry Pi, 7.5inch, 800×480 resolution, with embedded controller, communicating via SPI interface. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
No backlight, keeps displaying last content for a long time even when power down. Ultra low power consumption, basically power is only required for refreshing.
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano. SPI interface, for connecting with other controller boards like Raspberry/Nucleo, etc. Onboard voltage translator, for 3.3V/5V MCUs.
Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/STM32).
69,99 € EN AMAZON
Waveshare
Waveshare 13.3inch E Ink Spectra 6 (E6) Full Color E-Paper Display with Hat+ Standard Driver Hat, 1600x1200 Pixels, SPI Communication, E-Ink Display
Envío gratis
81
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#6
▼ Mostrar más
▲ Mostrar menos
E-Paper Display With HAT+ Standard Driver HAT(Features improved interoperability). Adopts E Ink Spectra 6 (E6) technology, featuring high contrast and high color saturation
No backlight, keeps displaying last content for a long time even when power down. Ultra low power consumption, basically power is only required for refreshing
Comes with e-Paper Driver HAT: Features Standard Raspberry Pi 40PIN GPIO header, supports Raspberry Pi series boards. Onboard voltage translator, compatible with 3.3V / 5V MCUs. Adapting SPI interface for Raspberry Pi/ESP32/STM32, etc
Adopts Raspberry Pi HAT+ standard to improve interoperability, helping the users to design and develop faster, easy to use with other peripherals and extend more functions for Raspberry Pi
Can provide with online development resources and manual (e-Paper driver HAT circuit diagram, examples for Raspberry Pi/ESP32/STM32)
362,99 € EN AMAZON
Waveshare
Waveshare 7.3inch 6-Color E-Paper Screen with Driver Board, E-Ink Display(E Type), Low Power Consumption, 800x480 Pixel, SPI Communication, Suitable For Price Tag, Asset/Equipment Tag, Shelf Label...
Envío gratis
78
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#7
▼ Mostrar más
▲ Mostrar menos
7.3inch e-Paper HAT (E) - with e-Paper Driver HAT. Adopts E_Ink Spectra 6(E6) technology, supports 6-Color display. Onboard voltage translator, compatible with 3.3V / 5V MCUs
No backlight, keeps displaying last content for a long time even when power down. With standard Pi 40PIN GPIO extension header for Raspberry Pi series boards/Jetson Nano
Ultra low power consumption, basically power is only required for refreshing. Adapting SPI interface for Raspberry Pi/Jetson Nano/STM32 controller boards
Can provide with development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/STM32)
Suitable For Price Tags, Asset/Equipment Tags, Shelf Labels, Conference Name Tags...
107,99 € EN AMAZON
Waveshare
Waveshare 4inch e-Paper E6(Spectra 6) Full-Color Supports Hat+Standard e-Ink Screen Module 600 x 400 Pixels SPI Communication, Low Power Consumption, Wide Viewing Angle
Envío gratis
78
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#8
▼ Mostrar más
▲ Mostrar menos
4inch e-Paper HAT+ (E), With HAT+ Standard Driver Board. With HAT+ Standard Driver Board. Adopts E Ink Spectra 6 (E6) technology, featuring high contrast and high color saturation
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Can provide with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/RDK X3/STM32)
e-Paper driver board: Standard Pi 40PIN GPIO header, suitable for Raspberry Pi series boards/Jetson Nano/RDK X3. Adopts Pi HAT+ standard to improve interoperability, helping the users to design and develop faster, easy to use with other peripherals and extend more functions for Raspberry Pi. Adapting SPI interface for connecting with controller boards like Raspberry Pi/Jetson Nano/RDK X3/STM32, etc. Onboard voltage translator, compatible with 3.3V / 5V MCUs
85,99 € EN AMAZON
Waveshare
Waveshare 7.3inch ACeP 7-Color E-Paper Hat(with PCB), 800x480 Resolution, SPI Interface, Low Power Consumption, Wide Viewing Angle, Paper-Like, for Shelf Label/Industrial Instruments, etc
Envío gratis
70
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#9
▼ Mostrar más
▲ Mostrar menos
7.3inch ACeP 7-Color E-Paper E-Ink Display Module(with PCB driver board), 800×480 Pixels, SPI interface, for connecting with controller boards like Raspberry Pi/Jetson Nano/Arduino/STM32, etc
Adopts Advanced Color ePaper (ACeP) technology, allows displaying seven colors. Applicable to price labels, asset equipment labels, electronic shelf labels, conference nameplates, etc
No backlight is required, and the display content of the last screen can be kept for a long time after power down. Onboard voltage translator, compatible with 3.3V/5V MCUs
Very low power consumption, which is only used when refreshing. with standard Pi 40PIN GPIO extension header, supports Raspberry Pi series boards/Jetson Nano
Provide complete online development resources and manual(driver board schematic, examples for Raspberry Pi/Arduino/STM32)
97,99 € EN AMAZON
Waveshare
Waveshare 2.13inch e-Paper Display Hat 250x122 Resolution SPI E-Ink Screen Electronic Paper Module with Embedded Controller Partial Refresh for Raspberry Pi Zero/Zero W/Zero WH for pwnagotchi Project
Envío gratis
69
CALIDAD BUENA
VER EN AMAZON
Amazon.es
#10
▼ Mostrar más
▲ Mostrar menos
V4 Latest Version.Note:Please check the verison and use the corresponding demo code in wiki.No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+,Jetson Nano,,but incompatible with Netatmo
SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs
Comes with development resources and manual (examples for Raspberry/Jetson Nano/Arduino/STM32)
20,99 € EN AMAZON
waveshare e-ink
waveshare e-ink esp32
e ink
e-ink
telefono e ink
e ink notebook
e ink display
e-ink display
movil e ink
movil e-ink
#1 GANADOR
